charcoal chimney starter - Diy build, quick question

[PeanutZA]

Where are you getting the stainless from?

Looks really good. Well done.

Sent from my GT-I9100 using Tapatalk 2

[wozzad]

Thanks.

Stainless is 316ti @1.25mm- I have a fair whack of it, but this piece was an offcut from a high end cookerhood.

Mirror one side, brushed the other side. Genuine pain in the nuts to from a cyl with no rollers. This was formed round a boc o2 bottle, with many MANY swear words! ( hence its not really that round)

[PeanutZA]

And the mesh on the way to you?

Sent from my GT-I9100 using Tapatalk 2

[wozzad]

304, 1.6mm with 11mm square openings.

Its free so it'll do! Mastered cutting shapes for a cone. either need a former, or will put several bends in it, more like a pyramid.

stainless handle will finish it off!

[wozzad]

Just noticed your real name....SNAP!

[PeanutZA]

Haha yeah. Not too many rabbit homes around.

Sent from my GT-I9100 using Tapatalk 2

[wozzad]

Lol, very true.

me, you, the guy that shot the sheriff, and the guy that stole from tesco!

[keith157]

Lol, very true.

me, you, the guy that shot the sheriff, and the guy that stole from tesco!

Uh guys there's the late "Zevon" one of the greatest songsmiths of his generation (IMHO)

Looks like a great build, so assuming you were daft enough to start production how much would one work out at????

[wozzad]

The stainless sheet would be a little less then £10


Stainless mesh around £4, handle in stainless around £5.

So cost is £20 all day..so retail would be more like 40.


Mine was very much free though, everything I needed was lying around!